Made a PyPortal Stand by Adafruit

I made a PyPortal Stand, printed from Adafruit's design.

This makes a great little desktop mini-display!

Printed on a FlashForge Finder in black PLA filament from Hatchbox.

It printed fine without supports or a raft. I printed with a brim, but the bottom still curled a bit because my print bed needs some adjustment. I evened it out with rubber feet, but that changed the center of mass a bit so it's a little forward-tippy. 🤷

It was easy to mount with nylon M2.5 standoffs and screws. I used a nut, small standoff, and medium screw for each of the 4 mounting holes, finger-tightened.


Likes

Aaron Parecki
Eddie Hinkle